Bachmann English Electric Deltic

Scale:
HO Scale


This installation of TCS EU621 Decoder is for HO Scale Bachmann model of the English Electric Deltic locomotive and was performed by Robert Lewis, UK.

This is a Bachmann model of the English Electric Deltic locomotive, commissioned as a limited edition by the National Railway Museum in York. The original locomotive built in 1955  has two 18 cylinder engines with the cylinders arranged in a triangular formation, generating a total of 3,300 hp, the most powerful single-unit diesel in the world at the time. It was known as DP1, although it never carried a running number, just the name "Deltic".

To remove the body shell it is necessary to remove the 8 crosshead screws, located in the main underframe, at the corner of each bogie. Once all 8 screws are removed, the body can be lifted straight off the chassis.
The original blanking plug is shown here inside the red square, gently pull this upwards squarely. For future use, it can be stored in the hollow in the casting to the right, held down with a bit of tape.
To install the TCS EU621 decoder align the pins with the decoder and gently push down.
Once fitted, test on the test track before refitting the body. Once tested and programmed, refit the body and the 8 securing screws.

Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. Over time, the acidic properties of liquid or paste flux will begin eating away at the fiberglass PCB and will damage it. Use only Rosin-core solder or no-clean flux approved for electronics use.

TCS recommends the use of Kester "44" Sn63 Pb37, .015" diameter Rosin-core solder. Kester part number 24-6337-0007.

You can order this solder from the following retailers:
Digikey - PN:KE1110-ND
Techni-Tool - PN:488SO6775

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more than a 1/32 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire than half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire