Atlas Train Master H-24-66

Scale:
HO Scale


WOWKit used in this installation

WDK-ATL-4

Which includes the following items:

Decoder
Motherboard
Speaker Kit
Keep Alive®

KA4



DXI Installation

This was performed by our friends from DCC Xpress installations. 
They offer high quality WOWSound installations for a flat rate complete with free return shipping! 
You can find them at: www.dxinstalls.com

This installation is for a HO-Scale Atlas H-24-66 using a TCS WOW121-Diesel Decoder, AS-MB2 Motherboard, KA4 with Keep Alive® and 32mm WOWSpeaker kit by TCS.

HO-Scale Atlas H-24-66 prior to installation.
To start off this install, we must first remove the front and rear couplers screws as indicated above and remove their housings.
With the couplers removed gently pull apart the shell at the two ends and along the sides and lift the shell off of the frame. 
Take care with the handrails as you lift off the shell so they don't break.
Shown with the shell off. Unplug the JST connectors and remove the original lighting board.
With the board off, take note of the wiring to be sure and replace it in its correct location.
Attach the AS-MB2 onto the motor mount tabs and plug the JST connectors in the appropriate locations.
Solder the KA4 Keep Alive® to the AS-MB2 motherboard and using hot melt glue, securing it to the inside top of the front of the shell.
Next, insert the 32mm speaker plug into one side of the speaker ports. This plug is included in your kit and we have found this greatly enhances the sound quality of your locomotive.
With this done, solder the speaker wire leads to the AS-MB2 motherboard and place the 32mm speaker in the other port within the frame, securing it with hot glue. NOTE: You must be very careful to avoid getting glue on the speaker cone. Glue on the speaker will ultimately cause it to produce no sound and fail.
Plug in your WOW121-Diesel decoder.
Lastly, in order to keep the wires neat and prevent possible shorts, lace the wires into a bundle using lacing cord.
Now you can close up the locomotive and reinstall the coupler assemblies. Be sure to be mindful of wire routing and reassembly of the shell as to not damage or foul the installation. Your Atlas H-24-66 is now WOWSound equipped and ready to roll!

Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. Over time, the acidic properties of liquid or paste flux will begin eating away at the fiberglass PCB and will damage it. Use only Rosin-core solder or no-clean flux approved for electronics use.

TCS recommends the use of Kester "44" Sn63 Pb37, .015" diameter Rosin-core solder. Kester part number 24-6337-0007.

You can order this solder from the following retailers:
Digikey - PN:KE1110-ND
Techni-Tool - PN:488SO6775

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more than a 1/32 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire than half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire

Lacing Cord

In order to keep the wires neat and prevent possible shorts, we recommend lacing the wires into a bundle using lacing cord. Lacing cord is a wax impregnated string used for wire bundling and making harnesses. There are many choices of lacing cord available from Digikey www.digikey.com
We use part number 802534B BK032-ND