Atlas GP30 Ph.1 (2006 edition)

Scale:
N Scale


This installation uses the following decoder:


This installation is for N Scale Atlas GP30 Ph.1 (2006 edition) and uses TCS ASD4 Decoder and was performed by A.G.

These three pictures above show detailed Atlas GP30 Ph.1 locomotive prior to the TCS ASD4 decoder installation.
Take both halves of the frame apart, remove original light board that the locomotive came with and insert the ASD4 decoder. and make sure they ARE touching their proper spots on the underside of the decoder. Put both sides of the frame together and make sure that all four contacts of the decoder are fitted into the chassis so that they create physical/electrical contact. Install both trucks, power pick-up rails , and tighten the two phillips screws on the chassis. Place the shell back and test your locomotive on the track.

Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. Over time, the acidic properties of liquid or paste flux will begin eating away at the fiberglass PCB and will damage it. Use only Rosin-core solder or no-clean flux approved for electronics use.

TCS recommends the use of Kester "44" Sn63 Pb37, .015" diameter Rosin-core solder. Kester part number 24-6337-0007.

You can order this solder from the following retailers:
Digikey - PN:KE1110-ND
Techni-Tool - PN:488SO6775

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more than a 1/32 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire than half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire