Kato EMD SD80MAC

Scale:
HO Scale


This installation uses the following decoder:

DP5



This installation documentation is for the HO Scale Kato EMD SD80MAC. This installation uses the DP5 decoder, and was performed by A.G.

The pictures above show the locomotive prior to the decoder installation.
Grasping the shell at the center top of both sides (being careful not to crush the grills), lift the shell straight up and off of the chassis. Picture of the locomotive with its shell removed.
Here is the close up picture of the original light board with 8pin socket (marked in red) Remove the clips (two of them) as shown in the picture above.
Plug in the decoder so that Pin #1 of the decoder lines up with Pin #1 of the socket. Pin #1 will be designated with a "1" or a small arrow/chevron. Hold the shell in one hand and the chassis in your other hand. Lining up the front of both pieces, lower the shell onto the chassis, keeping the lower edge of the shell parallel with the chassis. Both parts will click together.

Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. Over time, the acidic properties of liquid or paste flux will begin eating away at the fiberglass PCB and will damage it. Use only Rosin-core solder or no-clean flux approved for electronics use.

TCS recommends the use of Kester "44" Sn63 Pb37, .015" diameter Rosin-core solder. Kester part number 24-6337-0007.

You can order this solder from the following retailers:
Digikey - PN:KE1110-ND
Techni-Tool - PN:488SO6775

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more than a 1/32 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire than half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire